You also have to wait for a couple of seconds after pushing the headset button before talking so that your initial words are not cut off and release the button immediately after finishing.Ĭommunication on a two-way radio often relies on common short-cut phrases. Move to an open or higher area if you are in a basement and having trouble connecting.Īlways keep your messages brief as others are waiting in line with their emergency messages.Hold the radio above your head with the antenna on top to improve the audio.Check if your radio is on scanning mode to hear others, but others cannot hear you.If there is a problem with hearing while others are speaking, ensure that your volume is up.If you are having some problems with your radio, there are certain tricks you can follow. Press the headset button to the cord to talk and release to receive the message. Keep your mic 1 to 2 inches away from your mouth for better transmission but do not remove the foam over the mic. Attach the headset to the connector until you hear a pop and test with another radio to see if you can listen to the audio. Make sure that your radio is off when you attach your headset. Do not keep pushing the button because you will be forbidding someone else from speaking during an emergency. Keep your message ready before pushing the PTT button because nobody can speak or be heard while you press the PTT. Release the PTT button to hear the voice from the other end. Keep the microphone 10 to 15 centimetres away and speak at a normal voice level. After it clears, you push and hold the PTT button. If you wish to communicate with someone, you have to wait for the channel to clear. This light is a battery indicator, shows whether the radio is on, remains on when someone else is speaking on the radio and keeps on flashing if the radio is scanning for other channels. Besides the channel indicator, you will find an LED indicator light. The dot between the odd numerals represents the consecutive even numbers. The channels are consecutively marked 1 ° 3 ° 5 with only odd numerals as indicators of the channels. To change the channel, you will see a smaller dial on the side of the radio. Finally, make sure you are on the correct channel and adjust the volume to a comfortable, audible level. Next, switch on the radio either through the volume button or through the on/off button. The first thing you need to ensure is that the battery is ultimately charged. Even though they may seem like a thing from the past, two-way radio in Australia is exceedingly used as a reliable form of communication during emergencies like forest fires or floods. Analogue Vs Digital Two Way Radios – Wireless 2-WayĪ two-way radio can transmit and receive a message with similar radios operating on the same radio frequency (channel).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |